跳至主要内容

Several installation point for saving pump energy

1,Shorten the pipeline as much as possible.
2,Do not use “antiaircraft gun” type outlet pipe, because this type of outlet pipe increases energy consumption, and the outlet of water pump should be facing the water pool.
3,Increase the outlet pipe diameter as much as possible.
4, Remove the blockage in the pipeline in time , objects remain in the inlet pipe, impeller or diversion shell flow channel, will reduce the outlet water.
5, Try to use coupling to drive directly, because the coupling direct transmission is more efficienct than belt drive.
6, Under the premise of ensuring clean water, you can remove the filter.
7,Check the sealing parts of the pump carefully to prevent the pump from entering the air, if the pump is in the air, the water output will be significantly reduced.
8,You can choose electric motor drive than choose a diesel or a gasoline engine.Also ,you can choose 3 phase motor than single phase motor.

评论

发表评论

此博客中的热门博文

Pressure fluctuation propagation of a pump turbine at pump mode under low head condition

Pressure fluctuation at the vaneless space and vanes passages is one of the most important problems for the stable operation of a pump turbine. The fluctuation appears in any operating condition. Much research has been done on the pressure fluctuation of hydraulic machinery. However, the details of pressure fluctuation propagation of the pump turbine at the pump mode have not been revealed. The modern pump turbine with high water head requires the runner to be “flat”, which would induce pressure fluctuation more easily than the low head pump turbine. In this article, a high head pump turbine model is used as the research object. As the pressure fluctuation at off-design point is more serious than at the design point, the low head condition is chosen as the research condition. Pressure fluctuation at the vaneless space and vanes passages is predicted by the computational fluid dynamics method based on k- shear stress transport model. The experiment conducted on the test rig of the Har...
发表评论
阅读全文

Causes of Electric Motor Burning by Water pump

1. First, find out whether the motor burns the bearing (mechanical fault) or the coil (electrical fault). If it is the fault of burning coil, it is mainly caused by overcurrent, sometimes too high or too low voltage will also cause the coil to heat and short circuit, so check that the voltage when running is too different from the rated voltage.There may be several reasons for over-current short-circuiting: A. the equipment is overloaded to make the motor run for a long time at rated or over rated current. In particular, the starting current of the motor is 3-5 times that of the rated current. Therefore, we should try to avoid running with load or full load when starting the equipment (mainly depending on the matching allowance of rated current and normal operating current of motor). B, the motor works in a wet working environment. The insulation of the coils should be checked before the motor starts. The insulation requirements of different voltage grades are also different. May r...
发表评论
阅读全文

The advantages of the stainless steel centrifugal pump

The stainless steel  centrifugal water pump  can be used to convey various medium from tap water to industrial liquid at different temperature with different flow and pressure.the stainless steel  centrifugal water pump  can be used to transport the liquid,which PH Value is 5-9,the liquid can be slightly alkaline water,take off a mineral water,distilled water,swimming pool water,chloride liquid, they are anti-corrosion pumps. Stainless steel  centrifugal water pump  can last for a long time, stainless steel gear pump because the high quality material and light weight rotating parts, the stainless steel  centrifugal water pump  life expectancy is much longer than the ordinary pump. Gelaili pump industry ,supply professional stainless steel water pump. www.jxgllpump.com
发表评论
阅读全文