跳至主要内容

How does the pump prevent the freezing in the winter

The winter is coming, do you worry about that when you use the pump under low temperature conditions ,the pumps are easy to be frozen and the pump

body is easily be cracked? Don’t worry ,we have find some ways to prevent these circumstances.

1,We should run all water out of pipes and pump tunnels, after the Self suction booster water pump is discontinued in winter.it can prevent the pipe

or pump body to crack when the water fozen ,and clean up the dust and dirt on the surface of the pump or pipes.

2,We should have regularly checking for the pump,we should examing the impeller, bearing, sealing ring, valve and other vulnerable parts. If there is

serious wear of cast iron components or surface rust, the parts should be replaced as soon as possible.The clean the pump by gasoline,after that we

paint some anti-freezing oil to the parts then fixed it.

3,For the pump cavity, connecting parts and other cast iron parts,we use the steel brush to clean up the rust, then coat them with antirust paint,

and then put in a place of ventilated and dry storage.

4,The screws which we remove from the pumps or pipes should be cleaned with diesel, coated with oil, and then re install or use plastic cloth is

positioned to prevent rust or lost.

5,The pump also need to wear clothes, exposed to cold outdoor work, we used cotton, towels, clothes and dressing waste exposed to outdoor water

pipes, faucets and other water facilities, achieve heat preservation effect.

6,For the frozen water pumps and pipes, do not open the water pump without the melting of the ice, which can easily cause the pump damage or

mechanical failure.

7,Thawing method suggested Chonglin thaw in the water above and then heated with hot towel, do not fire directly or by boiling water with baking hot,

so as to avoid the cracking of pipe or pump body.

Especially in the north of the winter, the outdoor temperature often reaches 10-30 degrees below zero, then there is a good maintenance of water pump

can not only prolong the service life of the pump, but also can make use of the pump efficiency and make full use of the winter. For scientific

protection pump also becomes more important.

Jiangxi Gelaili pump industry co.,ltd produce centrifugal water pump,we have CDL,CDLF series,CHL,CHLF series stainless steel pump,can be used as ro booster pump, shower pump,fire pump,coolant pump,aquarium water pump and so on,we also supply cast iron pump,they are WQ series dewatering pumps,dirty water pump and GD series pipeline pump.

Gelaili pump industry co.,ltd supplies you competitive price and high quality products.

评论

此博客中的热门博文

Causes of Electric Motor Burning by Water pump

1. First, find out whether the motor burns the bearing (mechanical fault) or the coil (electrical fault). If it is the fault of burning coil, it is mainly caused by overcurrent, sometimes too high or too low voltage will also cause the coil to heat and short circuit, so check that the voltage when running is too different from the rated voltage.There may be several reasons for over-current short-circuiting: A. the equipment is overloaded to make the motor run for a long time at rated or over rated current. In particular, the starting current of the motor is 3-5 times that of the rated current. Therefore, we should try to avoid running with load or full load when starting the equipment (mainly depending on the matching allowance of rated current and normal operating current of motor). B, the motor works in a wet working environment. The insulation of the coils should be checked before the motor starts. The insulation requirements of different voltage grades are also different. May r...

The advantages of the stainless steel centrifugal pump

The stainless steel  centrifugal water pump  can be used to convey various medium from tap water to industrial liquid at different temperature with different flow and pressure.the stainless steel  centrifugal water pump  can be used to transport the liquid,which PH Value is 5-9,the liquid can be slightly alkaline water,take off a mineral water,distilled water,swimming pool water,chloride liquid, they are anti-corrosion pumps. Stainless steel  centrifugal water pump  can last for a long time, stainless steel gear pump because the high quality material and light weight rotating parts, the stainless steel  centrifugal water pump  life expectancy is much longer than the ordinary pump. Gelaili pump industry ,supply professional stainless steel water pump. www.jxgllpump.com

Difference between suction stroke and lift head of water pump

Pump self-priming capacity is also called maximum self suction height.It is the maximum height at which the water is pumped (the vertical distance between the pump and the the liquid surface to be pumped) without fill in water into the pump tunnel. General water level is lower than the location of the pump, you need to pump self-priming capacity.For example ,if we need to pump water from a river ,we will not plan pipe first,so we need a pump which has self-priming capacity. Or we need to pump some corrosive liquid,we can not fill water into the water pump tunnel. Some centrifugal water pumps do not have self-priming capacity,they need to fill in water at first time of using. The pump lift is the height that pump can lift water up.We usually expressed in H,the the unit is meter. The lift of the centrifugal pump is based on the center line of the impeller.The lift Consists of two parts,first is the vertical height from the center line of the pump impeller to the surface of the water s...